Hi All,
GRC 10 SP13
I have implemented AC10.0/10.1: Create Rule Based on Risk Violation in Request, Using BRF+ Procedure Calls, and find a strange(as per me) behaviour. So, could you help me here.
I see that my requests(and BRF+ simulation) give desired result, only when 1071 is YES. I think, manual Risk analysis call should route requests to defined(as per decision table) Rule results/paths, and should not depend on parameter 1071. So, i set 1071 as NO, but my requests do not go to defined rule_results/paths. Only when i set 1071 as YES, they do.
i find this strange, as by using Manual procedure call, i do not require 1071, to do Risk Analysis.
Regards
Plaban